Problem 1: "The settings for AF should match the picture above for the STEP recommendations from the STEP Guide. In the INI tweak section on the STEP Guide, Anisotropic Filtering (AF) was turned off. Now it needs to be turned on using Inspector."
Question: WHICH Anisotropic Filtering, Anisotropic Filtering Mode or Anisotropic Filtering Settings? Either is possible, Guide instructions don't state which. If the statement "The settings for AF should match the picture above for the STEP recommendations from the STEP Guide" is correct then in my case the Anisotropic Filtering Settings have already been switched to OFF, but the Guide statement that something needs to be changed could equally refer to Anisotropic Filtering Mode. Clarification requested.
Problem 2: "Users not using ENBoost should set Anisotropic filtering setting as indicated below. ENBoost users should ensure the Anisotropic filtering setting is off and set ForceAnisotropicFiltering is set to true in theenblocal.ini file."
This seems to contradict the statement in the STEP 2.10.0 Guide: "YES, ENBoost is needed by EVERYONE, including those that do not use ENB Presets!"
Once again, clarification requested.