Jump to content


Issue using MO2 with Mator Smash


  • Please log in to reply
3 replies to this topic

#1 Tonycubed2



  • Citizen
  • 2 posts

Posted 16 November 2019 - 12:54 PM



I am a new convert to MO2.  Reluctantly I have actually found it to be very modder friendly and a lot easier to manage than Vortex. I have just reinstalled everything on my computer due to a bad hard drive.  So everything is fresh and virgin.  No traces of any other organizers or dead utilities.  Kind of nice actually.  Was like 10 years of junk.


But after installing Mator Smash inside MO2 I am having an issue where Mator Smash is convinced the patches to masters are not in right sequence.  This is not accurate looking at my MO2 settings.  Skyrim Se is running great.  Please see attached uploaded picture. 


Tutorials I have found, such as the Gamer Poets tutorial, are too out of date and cannot help.  Nothing in 2019. Tried reddit, nothing current where this is addressed.  Tried discord, but that one may take some hours or days to get an answer.  I really have tried to find the answer.  I like the idea of motor smash.  Plan b is wry bash and ssedit merged patch but that will take me many hours due to my sot mods having so many npcs placed in so many places.

Attached Files

Edited by Tonycubed2, 16 November 2019 - 12:55 PM.

  • 0

#2 Tonycubed2



  • Citizen
  • 2 posts

Posted 16 November 2019 - 02:38 PM

mo_interface.log https://pastebin.com/mUVKx1Ze

plugins.txt https://pastebin.com/mTjk2U4T

modlist.txt https://pastebin.com/rg4Y55QT

loadorder.txt https://pastebin.com/umAH5MWN

mator smash load order: https://imagizer.ima.../923/bXLQTM.jpg

mator smash log: https://pastebin.com/KBP6NXFY

  • 0

#3 GSDFan



  • VIP-Supporter
  • PipPipPip
  • 1,008 posts

Posted 17 November 2019 - 01:01 AM

I would tend to agree with Mators Smash. Looking at the first few lines of the picture and loadorder.txt confirms it. Cutting room floor.esp is at line 14 and the Unofficial Skyrim Special Edition Patch.esp is at line 34, which it should be above it.


In the right pane make sure the load order is sorted by the priority column. It should be zero at the top. Clicking on the column header will change the sorting to ascending or descending. I would also install LOOT and run it on the load order. 

  • 0

#4 Mercury71



  • VIP-Supporter
  • 105 posts

Posted 17 November 2019 - 07:32 AM

Like Jarl writes, sort your load order with Loot. Patches must always load after the mods it patches.

Also i think the "PCE - USSEP Patch.esp" should be deactivated when using the "PCE USSEP + CRF Patch.esp"

Edited by Mercury71, 17 November 2019 - 07:36 AM.

  • 0

Also tagged with one or more of these keywords: help

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users